Hunter Fan Remote Not Working

Make sure that the power is turned on to the fan.

Ceiling fan decorative. The switches look like four sliding buttons that also appear on the back of the remote. You can troubleshoot hunter ceiling fan remote by following the methods below. Push the motor reversing switch firmly left or right to ensure that it is engaged.

Possibly at home depot or from hunter website research. Check the circuit breaker to ensure the power is turned on. This may seem like a rudimentary or obvious thing and yes we do start at the obvious before we move onto the not so obvious.

Hunter ceiling fans remote not working remote control troubleshooting. If you noticed that your ceiling fan remote control is not working then you must find the cause for this malfunction. Turn the power to your fan off wait one minute and then try again.

In terms of troubleshooting hunter ceiling fan remote controls much of the troubleshooting will be similar to troubleshooting other fans. Pairing a 2 series model hunter fan. First turn on the witch position to turn on the fan on the main service panel if the remote control is not working.

Make sure power switch is on. Once cleaned the remote responds with featherlight touch. A few important notes.

Change the batteries and try again or check that you have installed them properly check that the dip switches on the fan receiver and remote are on the same frequency. The setting in the remote must be the s. Pull the pull chain to make sure it is on.

Turn the power to your fan off at the wall switch or circuit breaker. It is very frustrating that the fan on button works but the fan off button stops responding and there is no way to turn the fan off. If the fan does not turn on or the light blinks and turns off the remote is not paired.

A change the battery in the handheld remote b if so change the code in your handheld and in the motor control module matching settings are mandatory and if it still does not work get a replacement remote module and remote handheld. This occurs because the contacts inside the remote are dirty.